Directional Stabilization Assistance Control Module -J759-, REMOVING AND INSTALLING: Removing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing Cover Trim From Bracket

Courtesy of AUDI OF AMERICA, LLC

-- Unclip the cover -1- from the bracket -arrow-.

-- Place a screwdriver on the retaining pin and press to release the Directional Stabilization Assistance Control Module -J759- slowly out of the retaining clip -1- -right arrow-.

Fig 2: Removing Driver Assistance Systems Front Camera

Courtesy of AUDI OF AMERICA, LLC

-- Remove the Driver Assistance Systems Front Camera -R242- out of the retaining plate guide toward the right in direction of -left arrow-.

-- Disconnect the connector and remove the Directional Stabilization Assistance Control Module - J759-.

Lens Shade, Removing

Fig 3: Pressing Clamps To Pull Lens Screen Out Of Bracket

Courtesy of AUDI OF AMERICA, LLC

-- Press the clips in direction of -arrow- and remove the lens shade downward from its bracket.