Directional Stabilization Assistance Control Module -J759-, REMOVING AND INSTALLING: Installing
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal. Note the following:
NOTE:
The camera vision range on the inside of the windshield must not be fogged up or dirty.
The retaining clip must be replaced each time the front camera is removed.
-- Remove the retaining clip -2- in direction of -arrow- from the mount -1- and insert a new one.
-- Clean the lens on the windshield with Cleaning SolutionD 009 401 04.
-- Calibrate the driver assistance systems front camera, refer to CALIBRATION PROCEDURE .