D-Pillar Trim Panel, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi Q5, 2016 Audi Q5, 2015 Audi Q5, 2014 Audi Q5, and 2013 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Follow all Safety Precautions when working with pyrotechnic components. Refer to PYROTECHNIC COMPONENTS SAFETY PRECAUTIONS .
Do not pinch the head curtain airbag when installing the D-pillar trim.

Install in reverse order of removal. Note the following:

NOTE:

If the trim clamps remain in the body mounting points, remove them and insert them in the trim.

Check clamps for damage or deformation, replace if necessary.

-- Install the D-pillar trim and press on it until the audibly latches.

-- Pull the rubber lip of the luggage compartment seal over the edge of the trim.