Lower Rear Lid Trim Panel, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi Q5, 2016 Audi Q5, 2015 Audi Q5, 2014 Audi Q5, and 2013 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Ensuring Clips & Rubber Buffers Installed

Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal. Note the following:

NOTE:

If the trim clamps -1- remain in the rear lid mounting points, remove them and insert them in the trim.

Check clamps for damage or deformation, replace if necessary.

-- Make sure all the rubber buffers -5- are in the trim.

-- First mount the rear lid lower trim -4- onto the centering pins -2- and -3- and press until it engages audibly.