Instrument Panel, Removing And Installing: Removing
-- Move the steering wheel as far down as possible.
-- Move the seat all the way back and adjust the backrest to a 45° angle.
- Follow all Safety Precautions when working with pyrotechnic components. Refer to PYROTECHNIC COMPONENTS SAFETY PRECAUTIONS .
- Follow the allocation of the airbag to the instrument panel.
-- Turn on the ignition.
-- Disconnect the battery ground cable with the ignition turned on. Refer to GROUND CABLE WITH Battery Monitoring Control Module -J367-, REMOVING AND INSTALLING .
-- Remove the instrument cluster gap cover. Refer to INSTRUMENT CLUSTER GAP COVER, REMOVING AND INSTALLING .
-- Remove the instrument panel cover on the driver side. Refer to DRIVER SIDE INSTRUMENT PANEL COVER, REMOVING AND INSTALLING .
-- Remove the side instrument panel vent. Refer to INSTRUMENT PANEL VENT, REMOVING AND INSTALLING, SIDE INSTRUMENT PANEL VENT .
-- Remove the MMI screen cover. Refer to MMI SCREEN COVER, REMOVING AND INSTALLING .
-- Remove the MMI screen. Refer to MMI SCREEN COVER, REMOVING AND INSTALLING .
-- Remove the Instrument Cluster. Refer to the appropriate Service Information .
-- Disconnect the connector to the Access/Start Authorization Switch. Refer to Controls .
-- Remove the center instrument panel vent. Refer to INSTRUMENT PANEL VENT, REMOVING AND INSTALLING, CENTER INSTRUMENT PANEL VENT .
-- Remove the radio. Refer to RADIO, REMOVING AND INSTALLING .
-- Remove the navigation system. Refer to NAVIGATION SYSTEM .
-- Remove the Climatronic Control Module -J255-.
-- Remove the Front Information Display Control Head Control Module -J523-. Refer to Communication .
-- Remove the center console. Refer to CENTER CONSOLE, REMOVING AND INSTALLING .
-- Remove the glove compartment. Refer to GLOVE COMPARTMENT, REMOVING AND INSTALLING .
-- Remove the Glove Compartment Mount. Refer to GLOVE COMPARTMENT MOUNT, REMOVING AND INSTALLING .
Before handling pyrotechnic components (for example, disconnecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.
-- Disconnect the passenger airbag electrical connector. Refer to FRONT PASSENGER AIRBAG UNIT WITH IGNITER, REMOVING AND INSTALLING .
-- Versions with a speaker: Remove the Mid-Treble Speaker from the center of the instrument panel. Refer to Center Mid-Treble Speaker -R158- .
-- Remove the Sunlight Photo Sensor -G107-. Refer to Sunlight Photo Sensor -G107-, REMOVING AND INSTALLING .
-- Remove the A-pillar upper trim. Refer to A-PILLAR TRIM PANEL, REMOVING AND INSTALLING .
-- Versions with a speaker: Remove the side mid-treble speaker in the instrument panel. Refer to Center Mid-Treble Speaker -R158- .
-- Remove the top left and right instrument panel bolts -1- in the A-pillar area.
-- Remove the bottom left and right instrument panel bolts -2-.
-- Remove the left and right air duct bolts -arrows- on the instrument panel.
-- Remove the instrument panel bolts -1- on the center of the instrument panel central tube.
-- Remove the instrument panel bolts -2- on the right of the instrument panel central tube.
-- Remove the instrument panel bolt -3- on the left of the instrument panel central tube.
Two technicians are needed to remove the instrument panel.
-- Disengage the instrument panel -1- at the bottom from the bracket -2- and remove it -arrow B-.
-- Carefully pull the instrument panel back from the instrument panel central tube -A arrows-.
-- Remove the instrument panel on the passenger side from the vehicle interior and lay it on a soft surface.