Rearview Camera -R189-, REMOVING AND INSTALLING: Removing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

The Rearview Camera -R189- has a trailing cable. The vehicle wiring harness couplings are located in the rear lid.

-- Remove the rear lid trim panel, refer to LOWER REAR LID TRIM PANEL, REMOVING AND INSTALLING .

-- Disconnect the connectors -1-, -2- and -3- in the rear lid and on the handle button.

Fig 1: Identifying Connectors -1-, -2- & -3-

Courtesy of AUDI OF AMERICA, LLC

The Rearview Camera -R189- is firmly attached to the handle button -4-.

-- Remove nuts -1- and -2-.

Fig 2: Identifying Nuts -1- & -2-, Retainer -3- & Button -4-

Courtesy of AUDI OF AMERICA, LLC

-- Pull the handle button -4- and Rearview Camera -R189- out of the retainer -3- inside the rear lid.