MULTIFUNCTION 4-Spoke Steering Wheel, Removing And Installing, From My 2013: Removing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the driver airbag, refer to OVERVIEW - DRIVER SIDE AIRBAG .

-- Remove the connecting wires from their guides inside the steering wheel.

-- Loosen the trim -2- with the multifunction buttons -arrows- and remove it approximately 5 mm from the steering wheel -1-.

Fig 1: Identifying Trim With Multifunction Buttons

Courtesy of AUDI OF AMERICA, LLC

-- Release the multifunction buttons -2- using the Trim Removal Wedge 3409 near the retainers -3-. Position the Trim Removal Wedge 3409 as illustrated.

Fig 2: Identifying Multifunction Buttons Are Attached To Trim

Courtesy of AUDI OF AMERICA, LLC

-- When doing this, be careful of the connectors to the tiptronic switches -2-.

Fig 3: Be Careful Of Connectors To Tiptronic Switches

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect connector -2- on the multifunction buttons.

-- Remove the trim and the multifunction buttons from the steering wheel.

The multifunction buttons are attached to the trim.

-- Disconnect the connector on the multifunction button.

-- Remove the screws -3- and press the multifunction button -2- out of the trim -1-.

Fig 4: Identifying Screws And Press Multifunction Button Out Of Trim, Removal

Courtesy of AUDI OF AMERICA, LLC

The additional wire on the right multifunction button remains on the button.