Right Instrument Panel Fuse Carrier, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Fuse Panel D, With Right Instrument Panel Fuse Panel Components

Courtesy of AUDI OF AMERICA, LLC

-- With the ignition switched off, disconnect the ground cable from the battery, refer to BATTERY, DISCONNECTING AND CONNECTING .

-- Remove the glove compartment, refer to Storage Compartments and Covers .

-- Release retaining clips -1- in the direction of the -arrow- and press the fuse panels -2- and -3- back and out of Fuse Panel D -SD-.

NOTE:

Ignore item -4-.

-- Unlock the release and remove from the fuse carrier, if equipped.

Fig 2: Releasing Clips And Removing Cover From Fuse Holder

Courtesy of AUDI OF AMERICA, LLC

-- Remove the fuses from the fuse carrier.

-- Release the retaining clips -arrows- and remove the cover from the fuse carrier.

-- Remove the connector retaining strip -1- -arrow- and remove the connectors from the plug-in socket.

Fig 3: Pulling Off Retaining Strip

Courtesy of AUDI OF AMERICA, LLC

NOTE:

The exact assignment of the right instrument panel fuse carrier can be found in the applicable wiring diagram, refer to appropriate SYSTEM WIRING DIAGRAM.