Fuse Panel In E-Box, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Fuse Panel B Components

Courtesy of AUDI OF AMERICA, LLC

-- Remove the fuse panel B, refer to Fuse Panel B -SB- IN E-BOX, REMOVING AND INSTALLING .

NOTE:

The relays -3- and -4- and fuse holder -1- remain clipped on.

The electrical wire -5- remains connected.

-- Release the retaining clip -arrow- and push the fuse panel -2- back and out and disengage it.

-- Unlock the release and remove from the fuse carrier, if equipped.

Fig 2: Releasing Clips And Removing Cover From Fuse Holder

Courtesy of AUDI OF AMERICA, LLC

-- Remove the fuses from the fuse carrier.

-- Release the retaining clips -arrows- and remove the cover from the fuse carrier.

-- Pull off retaining strip -1- for the connectors -arrow- and remove the connectors from the plug-in socket

Fig 3: Pulling Off Retaining Strip

Courtesy of AUDI OF AMERICA, LLC

NOTE:

The exact assignment of the fuse panel in the engine compartment E-box can be found in the applicable wiring diagram, refer to appropriate SYSTEM WIRING DIAGRAM.