Fuse Panel B -SB- IN E-BOX, REMOVING AND INSTALLING: Removing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

-- With the ignition switched off, disconnect the ground cable from the battery, refer to BATTERY, DISCONNECTING AND CONNECTING .

-- Remove the washer fluid reservoir filler neck, refer to WASHER FLUID RESERVOIR FILLER TUBE, REMOVING AND INSTALLING .

Fig 1: Identifying E-Box Cover & Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -1, 2 and 4- and remove the engine compartment E-box cover -3- -arrow-.

NOTE:

Disregard item -5-.

-- Release the retainers -A arrows- and remove the engine control module -arrow B-.

Fig 2: Release Retainers And Remove Engine Control Module

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -2-, if applicable.

Fig 3: Disconnect Electrical Connector If Applicable

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connectors -4- and remove the wire -3-.

-- Release the retainers -arrow- and remove the Fuse Panel B -SB- -1-.

-- Disengage the engine wiring harness at the E-box and lay bare.

-- Remove the wire -5-.

Fig 4: Identifying Fuse Panel B Components

Courtesy of AUDI OF AMERICA, LLC

-- Remove the relay -3- and control modules -4- from the Fuse Panel B -SB-.

-- Release the retaining clip -arrow-, push the fuse panel -2- back and out and disengage it.

-- Release the retaining clip and press the auxiliary fuse panel -1- back and out.

-- Release the retaining clips -arrows- and press the relay carrier -2- back and out of the bracket -1-.

Fig 5: Identifying Retaining Clips

Courtesy of AUDI OF AMERICA, LLC

-- Remove the Fuse Panel B -SB- from the engine compartment E-box.