RELAY/FUSE CARRIER MOUNT WITH Vehicle Electrical System Control Module -J519-, REMOVING AND INSTALLING: Removing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Disengaging Retaining Pins -1- On Mount At Side Guide In A-Pillar In Direction Of -Arrow

Courtesy of AUDI OF AMERICA, LLC

-- With the ignition switched off, disconnect the ground cable from the battery, refer to BATTERY, DISCONNECTING AND CONNECTING .

-- Remove the instrument panel, refer to INSTRUMENT PANEL VENT, REMOVING AND INSTALLING .

-- Remove the air duct to the left instrument panel vent, refer to INSTRUMENT PANEL VENT, REMOVING AND INSTALLING .

-- Remove the Vehicle Electrical System Control Module -J519-, refer to Vehicle Electrical System Control Module -J519-, REMOVING AND INSTALLING .

-- Remove the nuts -2-.

-- Remove the mount -3- from the threaded pins.

-- Disengage the mount retaining pins -1- at the side guide in the A-pillar -arrow- by pulling the mount upward.