RELAY/FUSE CARRIER MOUNT WITH Vehicle Electrical System Control Module -J519-, REMOVING AND INSTALLING: Installing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Installing Fuse Panel Mount

Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal. Note the following:

Tightening specification, refer to Figure.

-- Engage the retaining pins -1- on the mount -3- at the side guide in the A-pillar -arrow-.

-- Tighten the nut -2-.

-- Install the air duct to the left instrument panel vent, refer to INSTRUMENT PANEL VENT, REMOVING AND INSTALLING .

-- Install the instrument panel, refer to INSTRUMENT PANEL VENT, REMOVING AND INSTALLING .

-- Connect the battery. Take the necessary precautions, refer to BATTERY, DISCONNECTING AND CONNECTING . Vehicles with a high voltage system, refer to Battery -A- AND Auxiliary Battery -A1-, DISCONNECTING AND CONNECTING, VEHICLES WITH HIGH VOLTAGE SYSTEM .