Right A-Pillar Connector Station, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Right A-Pillar Connector Station

Courtesy of AUDI OF AMERICA, LLC

-- With the ignition switched off, disconnect the ground cable from the battery, refer to BATTERY, DISCONNECTING AND CONNECTING .

-- Remove the front left sill panel, refer to Passenger Compartment Trim .

-- Press the clip in the direction of the -arrow- and disengage the connector station -1- at the A-pillar.

-- Unclip the fuse panel -2- from the connector station.

-- Remove the relay and control modules.

Fig 2: Identifying Retaining Clips

Courtesy of AUDI OF AMERICA, LLC

-- Release the retaining clips -arrows- and press the relay carrier -2- back and out of the bracket -1-.

NOTE:

For the exact assignment of the passenger side A-pillar 6-pin connector station, refer to appropriate SYSTEM WIRING DIAGRAM.