Ribbed Belt Pulley With Freewheel, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

The Torque Wrench 1332 40-200Nm VAG1332 must be rearranged for installing the decoupling belt pulley with freewheel as follows:

-- Release the insert -1- and remove it from the handle part -2-.

Fig 1: Identifying Torque Wrench Socket Drive Grip

Courtesy of AUDI OF AMERICA, LLC

-- Turn the handle part -2- of the torque wrench 180° and reinsert the socket.

-- Set the rotation direction of the torque wrench socket to "left".

-- Next, screw the ribbed belt pulley with freewheel by hand onto the generator shaft until stop.

-- Install the Multi-Tooth Adapter T10474 -1- ribbed belt pulley with freewheel and attach the wrench.

-- Place a suitable tool -2- in the generator shaft.

Fig 2: Identifying Suitable Tool

Courtesy of AUDI OF AMERICA, LLC

-- Turn the generator shaft using the Torque Wrench 1332 40-200Nm VAG1332 -3- counter clockwise to tighten the ribbed belt pulley with freewheel.

-- Clip protective cap onto generator pulley.

Tightening Specification

Component	Nm
Ribbed belt pulley with freewheel to generator	80