Electric Drive Output And Control Electronics, Removing And Installing: Notes
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Torque Wrench 1331 5-50Nm VAG1331
- Hose Clamps - Up To 25mm 3094
- High Voltage Release Tool T40258
WARNING:
Working with high voltage cables:
- Do not support yourself or any tool on the high voltage cables or components. This could damage the insulation.
- Do not bend the high voltage cables excessively. This could damage the insulation.
- The round high voltage connectors are color-coded by an exterior color ring and are mechanically coded by the guide and code tabs. Always pay attention to the coding when connecting the round high voltage connectors to prevent mechanical damage to the high voltage connectors.
NOTE:
If replacing the control module, select the "Replace control module" function for the corresponding control module using the Vehicle Diagnostic Tester.