Seat Height Adjustment Motor, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi Q5, 2016 Audi Q5, 2015 Audi Q5, 2014 Audi Q5, and 2013 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
- Follow all Safety Precautions when working with pyrotechnic components. Refer to PYROTECHNIC COMPONENTS SAFETY PRECAUTIONS .
- Before handling pyrotechnic components (for example, disconnecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.
-- Raise the seat to make it possible to pretension the torsion bar.
-- Remove the front seat. Refer to FRONT SEAT, REMOVING AND INSTALLING .
-- Attach the front seat to the Engine/Transmission Holder - Seat Repair Fixture VAS6136. Refer to FRONT SEAT, MOUNTING ON FIXTURE FOR SEAT REPAIR .
-- Disconnect the connector -2- from the seat height adjustment motor.
-- Remove the locking nut -arrow-.
CAUTION:
Danger of damaging the threaded hole or the bushing in bearing point.
- The bushings cannot be replaced with workshop materials.
- If the bushings are damaged, the corresponding assembly parts must be replaced.
- A second technician is needed to be pushing on the seat via the backrest while removing the following screws.
-- Remove the bolt -1-.
-- Make sure the bushing -5- in the bearing point is not damaged.
-- Remove the screw -3- and remove the seat height adjustment motor -4- from the bracket.