LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 600 (Seat Frames) >> 72 Seat Frames >> Front Seats >> Front Backrest, Removing And Installing >> Front Backrest, Removing And Installing, Standard Seat/Comfort Seat/Sport Seat >> Removing

Front Backrest, Removing And Installing, Standard Seat/Comfort Seat/Sport Seat: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi Q5, 2016 Audi Q5, 2015 Audi Q5, 2014 Audi Q5, and 2013 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
  • Follow all Safety Precautions when working with pyrotechnic components. Refer to PYROTECHNIC COMPONENTS SAFETY PRECAUTIONS .
  • Before handling pyrotechnic components (for example, disconnecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.

-- Remove the front seat. Refer to FRONT SEAT, REMOVING AND INSTALLING .

-- Attach the front seat to the Engine/Transmission Holder - Seat Repair Fixture VAS6136. Refer to FRONT SEAT, MOUNTING ON FIXTURE FOR SEAT REPAIR .

-- Remove the Seat side trim on the tunnel side. Refer to TRIM, REMOVING AND INSTALLING, TUNNEL-SIDE .

-- Remove the seat side sill panel trim.

-- Disconnect the wiring harness connectors for the seat backrest and free up the disconnected wiring harnesses. Refer to MODULAR WIRE ROUTING WITH CORRUGATED TUBE ON FRONT SEAT .

NOTE:

The wiring harness between the connection point and the side airbag is continuous.

-- Disconnect the lower left and right rubber straps -1- and the seat pan.

Fig 1: Disconnecting Lower Left And Right Rubber Straps An Seat Pan
GWWA72-11058Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -2-.

Fig 2: Identifying Tip Backrest Forward Onto Seat Pan
GWWA72-10634Courtesy of AUDI OF AMERICA, LLC

-- Tilt the backrest -3- forward onto the seat pan -1-.

-- Press the seat pan upholstery to the side and carefully remove side airbag wiring harness -4- and, if necessary, all additional wiring harness (depending on option equipment) from the seat pan.

-- Remove the seat backrest.