Crankshaft seal (timing chain side), replacing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 Audi S4, 2008 Audi S4, 2007 Audi S4, 2006 Audi S4, and 2005 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

Special tools, testers and auxiliary items required

Fig 1: Identifying Pulling Fixture T10122

GW00000440

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Assembly Tool T10122

Fig 2: Identifying Extractor Hook T20143

GW00000441

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Pulling Hook T20143

Work procedure

Transmission removed.

Remove dual-mass flywheel → Dual-mass flywheel, removing and installing , drive plate → Drive plate, removing and installing .

Fig 3: Prying Out Sealing Ring Using Pulling Hook T20143/2

GW00015635

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Pry out sealing ring using Pulling Hook T20143/2.
Clean operating and sealing surfaces.

Fig 4: Identifying Seal, Sleeve T10122/1 And Assembly Tool T10122/2

GW00000443

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Insert assembly device T10122/1 onto pull sleeve T10122/2 and slide seal - A - onto pull sleeve.
Remove assembly device.

Fig 5: Installing Pull Sleeve T10122/2 With Sealing Ring Onto Crankshaft

GW00017923

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Install pull sleeve T10122/2 with sealing ring - 1 - onto crankshaft.

Fig 6: Pressing In Seal Evenly All Around Until It Reaches Stop Using T10122/3

GW00017924

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Press in seal evenly all around until it reaches stop using T10122/3.

The rest of installation is in reverse order of removal, note the following:

Install dual-mass flywheel → Dual-mass flywheel, removing and installing , drive plate → Drive plate, removing and installing .