Camshaft Position Sensor: Removing
WARNING: This page is about a different car, the 2012 Audi Q5, 2011 Audi Q5, 2010 Audi Q5, and 2009 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
-- Disconnect electrical connector on the respective camshaft position sensor.
-- Remove lower air filter housing section to remove the Camshaft Position (CMP) sensor 3 -G300- on cylinder bank 1. Removing lower section of air filter housing. Refer to LOWER AIR FILTER HOUSING
-- Remove coolant reservoir to remove the CMP)sensor 4 -G301- on cylinder bank 2.
-- Disconnect electrical connector to the engine coolant level warning switch -F66- on the bottom of the coolant reservoir and lay the reservoir aside with the coolant hoses -1 and 2- and -3- attached.