Ignition Overview
WARNING: This page is about a different car, the 2012 Audi Q5, 2011 Audi Q5, 2010 Audi Q5, and 2009 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition Coil Connector
- 4-pin
- Bolt
- 10 Nm
- 3-Pin Connector
- Camshaft Position (CMP) Sensor
- CMP sensor -G40- cylinder bank 1
- CMP sensor 3 -G300- cylinder bank 1
- CMP sensor 2 -G163- cylinder bank 2
- CMP sensor 4 -G301- cylinder bank 2
- O-ring
- Replace if damaged
- Coat with clean engine oil.
- Bolt
- 20 Nm
- Tightening specifications affect function of Knock Sensor (KS)
- Knock Sensor (KS)
- Contact surfaces between knock sensor and cylinder block must be free of corrosion, dirt and grease
- KS 1 -G61- cylinder bank 1
- KS 2 -G66- cylinder bank 1
- Removing and installing, refer to KNOCK SENSORS
- Spark Plug
- Removing and installing with the spark plug removal tool 3122 B, Refer to SPARK PLUGS, REPLACING
- 30 Nm
- Ignition coil
- Ignition coil 1 with power output stage -N70-
- Ignition coil 2 with power output stage -N127-
- Ignition coil 3 with power output stage -N291-
- Ignition coil 4 with power output stage -N292-
- Ignition coil 5 with power output stage -N323-
- Ignition coil 6 with power output stage -N324-
- Removing and installing, refer to IGNITION COILS
- To remove, use the ignition coil puller T40039