Oxygen Sensor after Three Way Catalytic Converter -G130-: Removing

WARNING: This page is about a different car, the 2012 Audi Q5, 2011 Audi Q5, 2010 Audi Q5, and 2009 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

-- Pull rear engine cover off -arrows-.

Fig 1: Pulling Rear Engine Cover Off

Courtesy of AUDI OF AMERICA, LLC

-- Free up the fuel supply line -4- and hose connection -1- to the Evaporative Emission (EVAP) canister on the air filter housing and on the air guide tube.

Fig 2: Identifying Air Guide Hose Components

Courtesy of AUDI OF AMERICA, LLC

-- Remove vacuum hose -2- from the air guide hose.

-- Remove air guide hose by loosening the hose clamp -3- and opening the clips -arrows-.

-- Disconnect electrical connector -5- for the Oxygen Sensor (O2S) after Three Way Catalytic Converter (TWC) --.

Fig 3: Electrical Connectors

Courtesy of AUDI OF AMERICA, LLC

-- Remove O2S after TWC -- -2- using a tool from the 3337.

Fig 4: Locating Oxygen Sensors - Cylinder Bank 1 (Right)

Courtesy of AUDI OF AMERICA, LLC

NOTE:

The installation location is shown with the engine removed.