High Pressure Pump: Removing
There is a risk of injury because the fuel is under very high pressure.
- The fuel pressure must be reduced to residual pressure before opening the high pressure area of the fuel injection system. Refer to BEFORE OPENING HIGH PRESSURE FUEL INJECTION SYSTEM .
The removal and installation of the high-pressure fuel pump can only be performed on a cold engine.
When installing the high-pressure fuel pump, make sure that no dirt enters the fuel system.
Catch escaping fuel with a rag.
The O-ring must always be replaced.
High-pressure fuel lines must always be fastened free of tension.
-- Remove lower section of the air filter housing. Refer to LOWER AIR FILTER HOUSING .
-- Remove bolts -arrows- and protective plate -1-.
-- Disconnect electrical connectors -1 and 6-.
-- Disconnect fuel supply line -2- and remove the threaded connection -5-.
-- Remove bolts -3 and 4- on the retaining clamps.
-- Remove bolts -arrows- and pry the end cover up carefully.
Do not change the angles of the fuel lines.
Never bend any of the fuel line mounting clamps.
If a mounting clamp was bent, or if the fuel line is being replaced, then the mounting clamps must also be replaced.
-- Carefully remove high pressure pump.
-- Remove roller tappet -1- from the housing.