LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 595 (2.0L - Generic Scan Tool - Engine Code(S): CPMA & CPMB (1 Of 2) (Sedan)) >> St Generic Scan Tool >> Diagnosis And Testing >> Diagnostic Modes 01 - 0A >> Diagnostic Mode 06 - Read Test Results For Specific Diagnostic Functions (My 2015) >> Monitor-ID A2 ($A2): Mis-Fire Cylinder 1 Data

Monitor-ID A2 ($A2): Mis-Fire Cylinder 1 Data

WARNING: This page is about a different car, the 2016 Audi A4 Quattro, 2015 Audi A4 Quattro, 2014 Audi A4 Quattro, and 2013 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

-- Connect the scan tool.

-- Start the engine and run at idle.

-- Select "Mode 6: Check test the results of components that are not continuously monitored".

Select "Monitor-ID A2 ($A2)".

-- Select the desired "Test-ID (TID)".

-- Check specified values at idle.

Test-ID (TID) DTC Component or System Min./Max. Values Additional Information
$0B P0301 Misfire Cylinder 1, Average value over 10 Driving Cycles. 0 - 65, 535 (counts) Refer to DTC P0301 in the DTC summary table.Engine Control Module --, 2015 MY => P0301
$0C P0301 Misfire Cylinder 1, in this Driving Cycle. 0 - 65, 535 (counts) Refer to DTC P0301 in the DTC summary table.Engine Control Module --, 2015 MY => P0301

-- If any of components or systems fail to meet the specified values. Refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTC or the corresponding diagnostic repair procedure DIAGNOSTIC MODE 03 - READ DTC MEMORY .

-- Switch ignition OFF.

scientia non olet · About LEMON Manuals