Fuel Pressure Regulator Valve - N276-, CHECKING

WARNING: This page is about a different car, the 2015 Audi A4 Quattro, 2014 Audi A4 Quattro, and 2013 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

General Description

The Engine Control Module -J623- regulates Fuel Pressure Regulator Valve -N276- directly at the High Pressure Fuel Pump to control the low pressure valve inside the High Pressure Fuel Pump.

Special tools and workshop equipment required

Multimeter
Wiring Diagram
Scan Tool

Test requirements

Fuses OK.
Battery voltage OK.
Switch OFF All electrical and electronic accessories.
Vehicles with Auto. Transmission, ensure Selector Lever position is in "P".
Vehicles with Manual Transmission, ensure Shifter Lever position is in "N" with Parking Brake applied.
Coolant Temperature: ≥ 80° C.
Observe all safety precautions: SAFETY PRECAUTIONS .
View clean working conditions: CLEAN WORKING CONDITIONS .
For Hybrid vehicles refer to: HIGH VOLTAGE SYSTEM GENERAL WARNINGS .

Test Procedure

Step	Procedure	Result / Action to Take
1	PERFORM: Preliminary Check to verify the customers complaint. Refer to PRELIMINARY CHECK . -- Was Complaint verified?	-- YES: GO TO: Step 2 -- NO: GATHER more information from customer about the complaint.
2	IGNITION: OFF. DISCONNECT: Fuel Pressure Regulator Valve -N276- harness connector. CHECK: Fuel Pressure Regulator Valve -N276- component connector terminals 1 to 2 for resistance. SPECIFIED VALUE: 1.5 to 11 Ω (at approx. 20° C). -- Was Value obtained?	-- YES: GO TO: Step 3 -- NO: REPLACE: Fuel Pressure Regulator Valve -N276-. Refer to appropriate repair information. GO TO: Step 5
3	IGNITION: ON. CHECK: Fuel Pressure Regulator Valve -N276- harness connector terminal 1 to ground for voltage. IGNITION: OFF. SPECIFIED VALUE: Battery voltage. -- Was Value obtained?	-- YES: GO TO: Step 4 -- NO: PERFORM: Visual Inspection of wiring and component. CHECK: Wiring for open, high resistance, short or harness connector for damage, corrosion, loose or broken terminals. REPAIR: Faulty wiring or connector. GO TO: Step 5
4	REMOVE: Engine Control Module - J623-. Refer to appropriate repair information. CHECK: Fuel Pressure Regulator Valve -N276- harness connector terminal 2 to the Engine Control Module - J623- harness connector T60 / 15 for resistance. SPECIFIED VALUE: 0.5 Ω (± 0.3 Ω). -- Was Value obtained?	-- YES: GO TO: Step 5 -- NO: PERFORM: Visual Inspection of wiring and component. CHECK: Wiring for open, high resistance, short or harness connector for damage, corrosion, loose or broken terminals. REPAIR: Faulty wiring or connector. GO TO: Step 5
5	Final Procedure Perform a road test to verify repair. -- Does the original DTC return?	-- YES: CHECK: Engine Control Module -J623- harness connector for any damaged, pushed-out pins. REPAIR: As necessary. If all electrical connections are OK: REPLACE: Engine Control Module -J623-. Refer to appropriate repair information. Clear the DTC's. Refer to DIAGNOSTIC MODE 04 - ERASE DTC MEMORY . Repair is complete. Generate Readiness Code. Refer to READINESS CODE . Return vehicle to Customer. -- NO: Perform the diagnostic procedure for any DTC's. If no DTC's return the repair is complete. Return vehicle to customer.