Electronic Damping Control Module -J250-, REMOVING AND INSTALLING: Notes
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
The control module is not designed for coding and adaptation when replaced, so the "Replace" function in "Guided Fault Finding " cannot be performed using the Vehicle Diagnostic Tester.
The new Electronic Damping Control Module -J250- can be used right away.
NOTE:
The Electronic Damping Control Module -J250- is installed behind the right side trim panel inside the luggage compartment.