Selector Shaft Seal: Installing
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2012 Audi S5, 2011 Audi S5, 2010 Audi S5, 2010 Audi A5, and 2009 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order, paying attention to the following:
-- Apply ATF to the circumference and the space between the sealing lips of the new shaft seal.
- Installed position: Open side of shaft seal faces transmission.
-- Slide the shaft seal onto the selector shaft.
-- Press the new shaft seal on as far as the stop using the T10135 and assembly lever -A-. Make sure the shaft seal does not tilt when doing this.
-- Install the spring pin on the selector shaft lever while it is still removed.
-- Slide the lever onto the selector shaft and install the spring pin.
-- Check the ATF level. Refer to ATF, CHECKING LEVEL AND CORRECTING .