Diagnostic Mode 09 - Read Vehicle Information

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi A4 Quattro, 2014 Audi A4 Quattro, and 2013 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Diagnostic Mode 09 makes it possible to access vehicle-specific information from the ECM and the TCM (where applicable).

NOTE:

Depending on scan tool and protocol used, Diagnostic Mode 09 and the information provided may be referred to by a different name.

Test requirement

No DTCs stored in the DTC memory.

Procedure

-- Connect the scan tool.

-- Ignition switched ON.

-- Select Mode 09: Vehicle information.

-- Select the desired Test-ID.

-- The information requested will be displayed on the scan tool screen.

The following table is a numerical list of all Test-IDs that may be selected.

Test-ID	Diagnostic text
02:	Vehicle identification number e.g.
	A different 17 digit number will be displayed for each vehicle
04:	Calibration identification e.g.
	Engine Control Module (ECM) --
	Transmission Control Module (TCM) --
06:	CVN (check sum) e.g.
	EC5AE460 the check sum is different for every control module version
	000D105

-- Ignition switched OFF.