LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 588 (2.0L - Generic Scan Tool - Engine Code(S): CAEB & CAED (1 Of 2)) >> St Generic Scan Tool >> Diagnosis And Testing >> Diagnostic Modes 01 - 0A >> Diagnostic Mode 06 - Read Test Results For Specific Diagnostic Functions (2016 My) >> Monitor-Id 3D ($3D): EVAP Valve Function Check

Monitor-Id 3D ($3D): EVAP Valve Function Check

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi A4 Quattro, 2014 Audi A4 Quattro, and 2013 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

-- Connect the scan tool.

-- Start the engine and run at idle.

-- Select "Mode 6: Check test the results of components that are not continuously monitored".

Select "Monitor-ID 3D ($3D)".

-- Select the desired "Test-ID (TID)" or "Hex-ID".

-- Check specified values at idle.

Test-ID (TID) (Hex-ID) DTC Component or System Min. Max. Additional Information
$80 P0441 Tank vent valve check from % DTEV: active test air balance at idle OK, (normal operation and short test 70). 0.300 % 1.999 % Refer to DTC P0441 in the DTC summary table. Engine Control Module -- 2016 MY => P0441 .
$88 P0441 Tank vent valve check from %DTEV: active test, oxygen sensor regulator deviating in lean direction (can only test OK), (normal operation and short test 70). 1.0 counts 65, 535 counts Refer to DTC P0441 in the DTC summary table. Engine Control Module -- 2016 MY => P0441

-- If any of components or systems fail to meet the specified values. Refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTC or the corresponding diagnostic repair procedure DIAGNOSTIC MODE 03 - READ DTC MEMORY .

-- Ignition switched OFF.

scientia non olet · About LEMON Manuals