LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 588 (2.0L - Generic Scan Tool - Engine Code(S): CAEB & CAED (1 Of 2)) >> St Generic Scan Tool >> Diagnosis And Testing >> Diagnostic Modes 01 - 0A >> Diagnostic Mode 06 - Read Test Results For Specific Diagnostic Functions (2012 - 2014 My) >> Monitor-Id $3C : Fuel Tank EVAP System Integrity/Leak Test (0.20/0.5MM)

Monitor-Id $3C : Fuel Tank EVAP System Integrity/Leak Test (0.20/0.5MM)

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi A4 Quattro, 2014 Audi A4 Quattro, and 2013 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

-- Connect the scan tool.

-- Start the engine and run at idle.

-- Select "Mode 6: Check test the results of components that are not continuously monitored".

Select "Monitor-ID $3C".

-- Select the desired "Test-ID (TID)" or "Hex-ID".

-- Check specified values at idle.

Test-ID (TID) (Hex-ID) DTC Component or System Min. Max. Additional Information
$83 P0456 Tank leak test: Pinhole leak (0.5 mm). 0 s 65535 ms Refer to DTC P0456 in the DTC summary table. Engine Control Module --, 2012 - 2014 MYS => P0456 .

-- If any of components or systems fail to meet the specified values. Refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTC or the corresponding diagnostic repair procedure DIAGNOSTIC MODE 03 - READ DTC MEMORY .

-- Ignition switched OFF.

scientia non olet · About LEMON Manuals