Outer Rear Belt Guide, Removing And Installing, AVANT: Removing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Lifting Spring Latch And Sliding Belt Guide Back Out Of Bracket

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

When removing and installing the belt guide, do not remove the bolts installed in the belt guide from below. They are set by the manufacturer.
Replace the entire belt guide if damaged.

-- Remove the luggage compartment side trim. Refer to LUGGAGE COMPARTMENT SIDE TRIM PANEL, REMOVING AND INSTALLING, AVANT .

-- Remove the foam piece from the opening under the belt guide -1-.

-- Insert a screwdriver into the opening under the belt guide and press the clip upward -arrow A- and hold it.

-- Push the belt guide to the rear -arrow B- until the bolt heads can be disengaged from the bracket on the body.

-- Rear outer right seat belt guide: Disconnect the connector from the Rear Parking Aid Warning Buzzer -H15-.