LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 586 (Passenger Protection, Airbags, Seat Belts (Sedan)) >> 69 Passenger Protection, Airbags, Seat Belts >> Seat Belts >> Front Belt End Fitting, Removing And Installing >> Installing

Front Belt End Fitting, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Belt Anchor -3-
GWWA69-10380Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal. Note the following:

CAUTION:
  • The spring -2- will get bent if it is removed incorrectly. Replace the three-point seat belt if the spring gets bent.
  • Move the spring -2- just far enough until it is possible to unlock the tab on the spring.

-- Connect the belt anchor -3- to the bolt -1- -arrow A- and pull it up -arrow B-, until the spring catches -2- audibly lock on the bolt heat.

scientia non olet · About LEMON Manuals