Passenger Occupant Detection System, Removing And Installing: Installing
Do not disconnect the connectors on the Passenger Occupant Detection System Pressure Sensor -G452- and the Passenger Occupant Detection System Control Module -J706-.
-- Clean the threaded bolt holes for self-locking nuts, for example using a thread tap.
-- Replace all self-locking bolts.
Install in reverse order of removal. Note the following:
- Follow all safety precautions when working with pyrotechnic components (refer to SAFETY PRECAUTIONS ) and on the passenger occupant detection system (refer to PASSENGER OCCUPANT DETECTION SYSTEM DEACTIVATION ADDITIONAL SAFETY PRECAUTIONS, MARKET-SPECIFIC ).
- Before handling pyrotechnic components (for example, connecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.
- Do not bend the passenger occupant detection system pressure hose and mat.
Make sure the connectors are installed correctly and are secure.
Ignition must be on when connecting battery. If pyrotechnic components (for example, airbag, belt tensioner) are not repaired correctly, they may deploy unintentionally after connecting battery. There must not be anyone inside the vehicle when connecting the battery.
-- Connect the battery ground cable with the ignition turned on. Refer to BATTERY, DISCONNECTING AND CONNECTING .
When installing a new service kit and after each repair to the front passenger seat during which the seat and/or the backrest cover is >>disengaged<<, a basic setting procedure must be performed for the passenger occupant detection system control module. Refer to PASSENGER OCCUPANT DETECTION SYSTEM DEACTIVATION ADDITIONAL SAFETY PRECAUTIONS, MARKET-SPECIFIC .
-- At the end, select the "Airbag" function in "guided fault finding" using Vehicle Diagnostic Tester.
- -J706 Passive occupant detection system control module basic setting