Headrest Cover And Cushion, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Install cover -1-.
-- Position the cover and slide it over the support with padding -2-.
-- Pull the left and right corners of the cover -arrow- over the support with the padding -2-.
-- Pull the cover so it is smooth.
-- Engage the locking channel -1-.
-- Bend the leg spring -2- up while sliding the trim -1- on.
-- Hold the leg spring -2- open until the trim -1- slides over the notches into the locked position.
-- Press the trim on firmly until it engages.
-- Align the cover -3- and pull it so it is smooth.
-- Make sure the cover lies on the padding without any wrinkles and without seam markings.
Install in reverse order of removal.