LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 584 (Seat Frames (Sedan)) >> 72 Seat Frames >> Rear Seats >> Rear Seat Backrest, Removing And Installing >> Rear Seat Backrest, Removing And Installing, Divided Rear Seat Backrest >> Installing

Rear Seat Backrest, Removing And Installing, Divided Rear Seat Backrest: Installing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

Versions with rear seat belt tensioner igniter:

WARNING:
  • Follow all Safety Precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS .
  • Before handling pyrotechnic components (for example, connecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.
NOTE:

Make sure the connectors are installed correctly and are secure.

Make sure the wires do not get caught.

WARNING:

Ignition must be on when connecting battery. If pyrotechnic components (for example, airbag, belt tensioner) are not repaired correctly, they may deploy unintentionally after connecting battery. There must not be anyone inside the vehicle when connecting the battery.

-- Connect the battery ground cable with the ignition turned on. Refer to WORKING ON THE AIRBAG SYSTEM .

scientia non olet · About LEMON Manuals