Rear Seat Backrest Frame Trim, Removing And Installing, Divided Rear Seat Backrest: Removing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Backrest Trim

Courtesy of AUDI OF AMERICA, LLC

-- Remove center armrest -3-. Refer to CENTER ARMREST, REMOVING AND INSTALLING, DIVIDED REAR SEAT BACKREST .

-- Push the padding and cover -1- to the side the remove the screw -4- for the backrest trim -2-.

-- Hold the backrest trim -2- by the lower edge and pull it as far as possible in direction of -arrow- off the backrest cover -1-.

Fig 2: Disengaging Retaining Tabs

Courtesy of AUDI OF AMERICA, LLC

-- Disengage the retaining tabs -4- and -5-.

NOTE:

Ignore -item 3-.

-- Remove the backrest trim -1- in direction of -arrow- from the backrest cover -2- and unhook the upper hooks -top arrows-.

Fig 3: Identifying Backrest Trim

Courtesy of AUDI OF AMERICA, LLC

-- Remove the backrest trim.