Lock Cylinder, Removing And Installing, Pass-Through Door Handle: Installing
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following:
CAUTION:
- Only remove and install the lock cylinder with the key inserted correctly. If that is not done, the tumblers and compression springs can fall out and the lock cylinder will be ruined.
- Check the installation position when installing the lock cylinder. It is not possible to lock the rear seat backrest correctly if the installation position is not correct.
-- Slide the lock -3- into the new lock cylinder -2- correctly.
-- Remove the cap -4- from the new lock cylinder.
-- Insert the lock cylinder in the pass-through door handle -1-.
- Installation position of the lock cylinder: the key slot must be vertical and the retaining tabs -upper arrow- must point to the right, opposite the direction of travel.
-- Turn the key 90° clockwise.
NOTE:
Make sure the lock cylinder is correctly installed into the retainers -lower arrows-.