Floor Panel For Bench Seat Mounting Grommets And Wire Frame, Checking And Aligning

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Check and Adjust the Floor Panel

Fig 1: Checking Floor Panel For Deformation And Adjust If Necessary

Courtesy of AUDI OF AMERICA, LLC

-- Check body openings -1- for deformations.

-- In the case of deformation, readjust the panel with a plastic hammer.

NOTE:

Remaining minor deformation is permissible.

Check and Adjust the Bench Seat Wire Frame

Fig 2: Checking And Adjusting Bench Seat Wire Frame

Courtesy of AUDI OF AMERICA, LLC

NOTE:

The illustration of the seat foam can deviate from the real bench seat. Regardless of the shape of the seat foam, dimension -a- must be measured between the upper edge of the seat foam and the upper edge of the wire frame.

-- Place the bench seat with the cover on a clean stable surface.

-- Check dimension -a- on both sides of the seat bench frame, from the padding to the upper edge of the wire frame. Dimension -a- >>must be 22 to 28 mm.<<

-- If dimension -a- does not meet the specification, the wire frame must be adjusted to meet the specification. For this purpose evenly adjust the wire frame in the area of the -motion arrows-.