Seat Belt For Child Seat, Checking Child Seat Restraint Function, Market-Specific
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
To check function, you must install entire belt system, including side trim.
Switching Hold Function On
- Pull belt webbing out completely up to stop.
Correct Function
- Belt must retract with a chattering sound.
- If retracting process is stopped, belt cannot be pulled out anymore.
Deactivating
- Belt retraction to about 100 mm remaining.
- Hold function must switch off with a remainder of 100 mm, at the latest. Belt functions normally again.
- If the seat belt child seat anchorage does not work, replace the seat belt