Selector Lever Handle: Removing

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2012 Audi S5, 2011 Audi S5, 2010 Audi S5, 2010 Audi A5, and 2009 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

-- Move the selector lever into N.

NOTE:

Both the selector lever handle and the selector lever boot are removed.

-- Pry the selector lever boot frame -1- out of the center console -arrows- using the 3409.

Fig 1: Unclipping Mounting Frame For Selector Lever Boot From Center Console

Courtesy of AUDI OF AMERICA, LLC

-- Secure the locking button in its extended position with a cable tie -arrow- as illustrated.

Fig 2: Securing Interlock Button In Pulled-Out Position Using A Cable

Courtesy of AUDI OF AMERICA, LLC

-- Fold the selector lever boot -1- upward and over the selector lever handle -2-.

Fig 3: Identifying Selector Lever Boot, Selector Lever Handle And Clamp

Courtesy of AUDI OF AMERICA, LLC

-- Open the clamp -arrow- and remove the selector lever handle with the selector lever boot without touching the locking button.