3. Check Locking Button In The Selector Lever Handle
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2012 Audi S5, 2011 Audi S5, 2010 Audi S5, 2010 Audi A5, and 2009 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
Make sure locking button moves easily.
- It must be possible to press the locking button without using great force.
- After releasing, the locking button must come all the way back out by itself.
-- Check the selector lever handle for correct installation if the specified values are not reached. Refer to SELECTOR LEVER HANDLE .
-- Check if the selector rod or selector lever is bent.
Function test:
- The ignition is switched on.
The locking button on the selector lever handle must be pressed for the following shifts. If it is not pressed, the selector lever cannot be shifted into the specified position.
- Move the selector lever from P into R and press the brake pedal at the same time.
- D into S
- N into R; stationary, press the brake pedal after waiting longer
- R into P
-- Check the selector lever handle for correct installation if the specified values are not reached. Refer to SELECTOR LEVER HANDLE .
-- Perform guided fault finding => and check the shift lock solenoid.
-- Adjust the selector lever cable. Refer to SELECTOR LEVER CABLE, ADJUSTING .