Raising Vehicle

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Before driving on to a lifting platform ensure there is sufficient clearance between low lying vehicle components and lifting platform.
Before driving a vehicle onto a lifting platform it must be ensured that the vehicle weight does not exceed the permissible lifting capacity of the platform.
To prevent damage to the underbody or to prevent the vehicle from tipping, lift the vehicle only at the mounting points.
Make sure that side member stiffener contacts support plate of lifting platform at center.
Never start engine and engage a gear with vehicle lifted so long as even one wheel has contact with the floor! There is a risk of an accident if this is not observed!
Use additional support blocks if it is necessary to work underneath the vehicle.

Using the Workshop Hoist

NOTE:

Always use a suitable rubber or wooden block between the jack and the vehicle.

Do not lift the vehicle at the engine oil pan, transmission, or on front or rear axles as serious damage may result.

-- Set the parking brake so that the vehicle cannot roll away.

-- Engage a gear or move the selection lever into P.

Fig 1: Identifying Front Side Member Vertical Stiffener

Courtesy of AUDI OF AMERICA, LLC

-- Position the mounting plate on the vertical reinforcement on the sill panel at the same level as the arrow marking.

Fig 2: Identifying Rear Side Member Vertical Stiffener

Courtesy of AUDI OF AMERICA, LLC

-- Position the mounting plate on the vertical reinforcement on the sill panel at the same level as the arrow marking.