Engine Speed Sensor -G28-

WARNING: This page is about a different car, the 2009 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Removing

-- Remove the noise insulation, to do this loosen the mounting parts -1, 2, 3-.

Fig 1: Identifying Noise Insulation Components

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -2-.

Fig 2: Location Engine Speed (RPM) Sensor -G28-

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -1- and the engine speed sensor.

Installing

Installation is performed in reverse order.

Tightening specification, refer to COMPONENT LOCATIONS OVERVIEW .