Overview - Radiator/Coolant Fan
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi A4 Quattro, 2015 Audi A4, and 2014 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 2.5 Nm
- Coolant Fan Control Module -J293-
- Removing and installing. Refer to Coolant Fan Control Module -J293-, REMOVING AND INSTALLING .
- Bolt
- 5 Nm
- Fan Shroud
- Removing and installing. Refer to RADIATOR, REMOVING AND INSTALLING .
- Coolant Fan -V7-
- Removing and installing. Refer to Coolant Fan - V7-, REMOVING AND INSTALLING .
- Bolt
- 3.5 Nm
- Backing Plate
- Rubber Bushing
- For the radiator
- Coolant Hose
- Lift the retaining clamp to remove
- O-Ring
- Replace
- Coolant Hose
- Lift the retaining clamp to remove
- O-Ring
- Replace
- Coolant Hose
- To the coolant reservoir
- O-Ring
- Replace
- Radiator
- Removing and installing with the fan shroud. Refer to RADIATOR, REMOVING AND INSTALLING .
- After replacing, replace entire amount of coolant.
- Retaining Pin
- Disengage and remove using screwdriver
- Rubber Buffer
- Radiator Bracket
- Bolt
- 5.5 Nm
- Coolant Fan 2 -V177-
- Not with the 400 W fan activation
- Removing and installing. Refer to Coolant Fan - V7-, REMOVING AND INSTALLING .
- Bolt
- 5 Nm
-- Remove the old O-ring -2- in the coolant hose -3-.
-- Coat the new O-ring with coolant additive and insert it in the coolant hose.
-- Press the coolant hose on to the coolant pipe -1- until you hear it engage.
-- Press the coolant hose on again and pull to make sure the connection is engaged correctly.