Coolant Fan Control Module -J293-, REMOVING AND INSTALLING: Removing

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi A4 Quattro, 2015 Audi A4, and 2014 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

When installing, bring all cable ties back to same positions.

-- Remove the noise insulation. Refer to OVERVIEW - NOISE INSULATION .

-- Remove the coolant fan connector -1- from the bracket and disconnect it by sliding the retainer back -arrow- and pressing the release down.

Fig 1: Disconnecting Coolant Fan Electrical Connector -1- From Bracket

Courtesy of AUDI OF AMERICA, LLC

-- Free up the electrical wiring harness to the coolant fan control module.

-- Disconnect the connectors -2 and 3-.

Fig 2: Coolant Fan Control Module -J293- & Connectors

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -arrow- and the coolant fan control module -1-.