LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 566 (2.0L - Cooling System - Engine Code(S): CAEB, CAED, CPMA & CPMB (Sedan)) >> 19 Cooling System >> Coolant Pump/Thermostat >> Engine Coolant Temperature Sensor -G62-, REMOVING AND INSTALLING >> Installing

Engine Coolant Temperature Sensor -G62-, REMOVING AND INSTALLING: Installing

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi A4 Quattro, 2015 Audi A4, and 2014 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal while noting the following:

NOTE:

Replace the O-rings.

To prevent coolant loss, immediately insert the new Engine Coolant Temperature Sensor -G62- into the connecting piece.

The hose connections as well as the air guide pipes and hoses must be free of oil and grease before installing.

Secure all hose connections with hose clamps of the same type as those equipped by the factory.

In order to be able to securely mount the air guide hoses on their connectors, spray the screws on the previously used clamps with a rust remover.

-- Install the Throttle Valve Control Module -J338-. Refer to Throttle Valve Control Module -J338-, REMOVING AND INSTALLING .

-- Check the coolant level, refer to Check The Coolant Level .

scientia non olet · About LEMON Manuals