LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 566 (2.0L - Cooling System - Engine Code(S): CAEB, CAED, CPMA & CPMB (Sedan)) >> 19 Cooling System >> Coolant Pipes >> Coolant Pipes, Removing And Installing >> Small Coolant Pipe, Removing And Installing >> Installing

Small Coolant Pipe, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi A4 Quattro, 2015 Audi A4, and 2014 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal while noting the following:

NOTE:

Replace the O-rings.

The hose connections as well as the air guide pipes and hoses must be free of oil and grease before installing.

Secure all hose connections with hose clamps of the same type as those equipped by the factory.

In order to be able to mount the air guide hoses on their connectors, spray the screws on the previously used clamps with a rust remover.

-- Connect the coolant hose to the coupling. Refer to Figure.

NOTE:

Do not reuse used coolant.

-- Fill with coolant. Refer to Filling .

scientia non olet · About LEMON Manuals