Engine Mount, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi A4 Quattro, 2015 Audi A4, and 2014 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Remove the tower brace. Refer to TOWER BRACE, REMOVING AND INSTALLING .

-- Position the Engine Support Bridge 10-222A on the left and right suspension strut towers as illustrated.

Courtesy of AUDI OF AMERICA, LLC

-- Engage the Engine Support Bridge - Spindle 10-222A/11 in the rear engine lifting eye.

-- Lightly pretension the engine using the spindle.

-- Remove the left front wheel.

-- Remove the front noise insulation. Refer to OVERVIEW - NOISE INSULATION .

-- Remove the left front wheel housing liner. Refer to WHEEL HOUSING LINER .

-- Vehicles with hydraulic power steering: remove the nut -2- and free up the bracket -1-.

Courtesy of AUDI OF AMERICA, LLC

-- If equipped: Disconnect and free up the connector -3- for the electrohydraulic engine mount solenoid valve.

-- Remove the engine mount bolts -1, 4 and 5-.

-- Move the engine mount retaining plate -2- to the side.

-- Remove the engine mount.

Courtesy of AUDI OF AMERICA, LLC