LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 560 (3.2L - Ignition/Glow Plug System - Engine Code(S): CALA (Sedan) (As Of 01.2014)) >> 28 Ignition/Glow Plug System >> Ignition System >> Camshaft Position Sensor, Removing And Installing >> Installing

Camshaft Position Sensor, Removing And Installing: Installing

WARNING: This page is about a different car, the 2009 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

-- Replace the o-ring and coat with clean engine oil.

-- Push in the camshaft position sensor carefully by hand.

-- Tighten the camshaft position sensor and connect the electrical connector.

-- Install in reverse order of removal.

scientia non olet · About LEMON Manuals