Fuel Pressure Sensor -G247-

WARNING: This page is about a different car, the 2009 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Removing

-- Remove the upper section of the intake manifold. INTAKE MANIFOLD, UPPER SECTION .

-- Disconnect the electronic connector from the fuel pressure sensor -G247- -4-.

Fig 1: Component Location under the intake Manifold Lower Section, Cylinder Bank 2 (left)

Courtesy of AUDI OF AMERICA, LLC

-- Remove the fuel pressure sensor -4-.

Installing

Installation is performed in reverse order.

Tightening specification, refer to INTAKE MANIFOLD, LOWER SECTION, WITH FUEL RAIL OVERVIEW

-- Install the upper section of the intake manifold, refer to INTAKE MANIFOLD, UPPER SECTION .