Transmission Tightening Specifications: Notes
WARNING: This page is about a different car, the 2013 Audi A4, 2012 Audi A4, 2011 Audi A4, 2010 Audi A4, and 2009 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The tightening specifications apply only to lightly greased, oiled, phosphated or blackened nuts and bolts.
Additional lubricant such as engine or transmission oil may be used, but do not use graphite lubricant.
Do not use any ungreased parts.
Tightening specification tolerance ± 15%.
| Component | Nm | ||
|---|---|---|---|
| Bolts and nuts | M6 | 9 | |
| M7 | 15 | ||
| M8 | 20 | ||
| M10 | 40 | ||
| M12 | 65 | ||
| Dual-mass flywheel to drive plate | 60 1) | ||
|
|||
-- Tighten the right driveshaft heat shield bolts -1- to 23 Nm.